Fuel Pump Replacement

Fuel Pump Replacement – Installation Instructions

1. Remove Protective Shell

  • Remove 12 screws and lift off shell.

2. Disconnect Power

  • Disconnect the fuel pump power cable from wiring harness.

3. Remove Fuel Lines

  • Pinch and slide hose clamps away from pump.
  • Pull fuel lines off each end.
  • Note: Fuel may be present — keep upright or plug.

4. Replace Pump

  • Slide pump out of rubber holder.
  • Install new pump upright (connector facing up).

5. Reconnect Fuel Lines

  • Slide lines onto correct sides and tighten clamps.

6. Reconnect Wiring

  • Plug pump back into wiring harness.
  • Prime pump according to manual.

7. Reassemble

  • Reinstall protective shell.

By purchasing and installing this product, you agree to the Polar Pal Sales Terms & Conditions