Jerry Can Adapter Instructions

Jerry Can Adapter – Installation Instructions

Important: Ensure the heater is fully powered off and disconnected before starting installation.

1. Remove Protective Shell

  • Remove 12 screws total (6 per side).
  • Lift off the protective shell and set aside.
  • Recommended: Ensure all fuel tanks and fuel lines are empty or new to prevent spills.

2. Prepare the Jerry Can Cap

  • Drill a ¼ inch hole through the jerry can cap.
  • Remove the nut from the Jerry Can Adapter (JCA).
  • Feed the fuel feeder pipe through the hole until the gasket sits flush.
  • Slide the nut over the pipe and tighten.
  • Ensure: The hole is clean (file smooth if needed) and no shavings enter the fuel system.

3. Cut Fuel Feeder Pipe to Length

  • Cut the feeder pipe to the correct length for your jerry can.
  • Ensure the pipe opening is not crushed or restricted after cutting.

4. Connect Fuel Line to JCA

  • Slide two metal clamps onto the black fuel line.
  • Attach one end of the black fuel line to the JCA pipe and tighten.
  • Insert the clear fuel line into the other end and tighten the second clamp.

5. Disconnect OEM Tank Fuel Line

  • Loosen the clamps between the fuel pump and the OEM tank.
  • Disconnect both ends and set line aside (you may reuse it later).
  • Remove the unused tank from the heater assembly if preferred.

6. Connect JCA Line to Fuel Pump

  • Slide two clamps onto the small black fuel line.
  • Connect this line to the fuel pump and tighten.

7. Reassemble Heater

  • Reinstall the protective shell.
  • Reconnect power.
  • Prime the fuel pump according to the manual.

By purchasing and installing this product, you agree to the Polar Pal Sales Terms & Conditions