Scepter Jerry Can Quick Connect/Disconnect Kit Instructions
Jerry Can Adapter Installation Instructions
Before You Begin
-
Inspect all components
- Ensure all hose clamps are present and tight.
- Verify the adapter, tubing, and fittings are free from damage or defects.
Step 1: Straighten the Pickup Tube
⚠ WARNING: Risk of burns — parts will be hot. Wear gloves.
- Boil a pot of water large enough to fully submerge the pickup tube and silver check valve.
- Submerge the pickup tube and check valve in the hot water for 10–12 seconds to soften the tubing.
- Remove the tube from the water and pull it straight while it cools, maintaining tension.
- Optional: Run the tube under cold water while holding it straight to speed up cooling.
IMPORTANT: DO NOT submerge the yellow cap adapter in hot water — it will melt.
Step 2: Install the Fuel Line
- Install the supplied 5 ft or 10 ft clear fuel line (3/16" ID) onto the male quick connector on the Jerry Can Adapter.
- Cut the fuel line to the desired length if needed.
Tip: Gently heating the end of the fuel line with a heat gun or hot water will soften the tubing and make installation easier.
Step 3: Install the Jerry Can Adapter Into the Fuel Jug
- Remove the existing nozzle from the fuel jug.
- The nozzle can be removed and stored, or left inside the jug.
- Unscrew the fuel jug cap.
- Insert the Jerry Can Adapter with the silver check valve positioned at the bottom of the jug.
- Orient the adapter so the concave curve faces the front of the fuel can.
- Reinstall the screw-on cap over the Jerry Can Adapter and tighten firmly.
Step 4: Bleed the Fuel Line
WARNING: Bleeding the fuel line is very important rather than using the fuel pump to prime/bleed the line. The fuel pump priming setting should not have to be used more than once, multiple dry priming attempts will damage the fuel pump.
If using this as an extended run kit for a diesel heater:
- Hold the loose end of the fuel line as high as possible.
- Blow gently into the vent of the fuel jug until most of the air is removed from the fuel line. ***Ensure doing this before plugging the end of the line with the quick connector on before installing onto the end of the fuel pump, this will make the bleeding process much easier***
- Plug or cap the fuel line to prevent air from re-entering.
Step 5: Connect to Equipment
- Slide the provided (2×) 7–9 mm hose clamps onto the fuel line.
- Connect the loose end of the fuel line to your equipment’s fuel inlet.
- Tighten all hose clamps securely.
Step 6: Test Before Use
⚠ IMPORTANT SAFETY STEP
- Run the equipment using this setup for at least 30 minutes.
- Closely inspect for fuel leaks, loose connections, or defects.
ALL leaks or issues MUST be corrected before the system can be left unattended.
⚠ QUICK CONNECTOR NOTICE:
All quick connectors are supplied with FKM (Viton) O-Rings to tolerate a wider range of chemicals. These O-Rings can become stiff in very cold temperatures.
If you experience difficulty connecting the quick connectors, replace the O-Rings on the male quick connector with the NBR spare O-Rings included at the bottom of your Jerry Can Adapter.
Keeping O-Rings lightly lubricated with petroleum jelly (Vaseline) will help extend connector life and make connecting and disconnecting easier.